75331: The Razor Crest Star Wars by 10th Feb,2023

By The content comes from other sites February 10th, 2023

This time, the inner box is not white, but has a cover painting, this style and the episode at the end of each episode when the cast and crew shot the same. This time, the inner box is very beautiful and can be cut out and collected.

Parts package has a total of 36 serial packages, the number of parts 6187pcs. parts are divided into 2 boxes, that is, can be put together by 2 people at the same time. A person to build the overall time to reach more than 18 hours, this time the designer made 2 sides look symmetrical but different details of the design, resulting in most of the structure can not use the symmetrical mirror build method, thus making the build time greatly lengthened.

There are four instruction books in total, and the front page of the cover shows in great detail that part of each book needs to be built. The first manual introduces the Razor Crown, some stills from the show, shooting footage, model quick disassembly part, interviews with designers, etc.. And the most important: how to carry this big guy, one hand must not drag the landing gear part, must drag the tail pod part.
The sticky paper part is mainly carbon jelly man, gunboat exterior lines and nameplates, etc. The dashboard pattern is all printed parts.

After the foundation of the bottom was laid, the flooring began to be laid, and the bottom part was built with glossy tiles and grid tiles to create a staggered pattern.

The head is divided into two levels, the upper level is the cockpit and the lower level is for equipment. This part restores the maintenance bay where the Glogu view rearranges the red and blue wires.

The green one is Boba Fett's outfit.

The Mandalorian thermal detonators are then stored in the Imperial marked case.

The next step was to start building the frame of the hull, where a large number of mechanical groups with perforated beam blocks were used.

The stern compartment uses a hydraulic rod device that can be opened. After this part is built, the length of the whole hull reaches 72cm.

Both measured doors can be opened, and the little manchild can use the boarding ramp on both sides to enter the Razor Crown. After the hatch is closed is almost invisible this door, the precision is very well designed.

The outer hull panel is fixed to the hull by 1x2 hinge blocks, while the curved and irregular parts are angled with ball joint parts. If it is a separate part, it will feel not too strong, but gradually build up to the back, the designer use other parts to limit or fix the panel.

The landing gear part is the module that can be used to fix the outer panel as mentioned earlier. And the landing gear part uses the upper and lower layers of several different angles of the fixed panel composition, with the upper layer of the panel to cover the lower layer of exposed parts. But the landing gear is not recyclable.

The outer panel at the top of the aft end of the hull is a huge monolithic piece. After this part is built, all the stuff inside box 1 is built.

▲The shape of box 1 after all completed.

Box 2 was the first to start building the middle upper hull panel, because the engine in the middle of the relationship, this part is divided into 2 parts, mainly located in the fixed engine beam on both sides.